450robot
02-10-2006, 07:52 PM
well, if some of your remember i had a problem with my elka lt's not rebounding after i pushed them to the ground
well, it was a simple fix, i have the spring crossover peices on upside down, and it made the shock fully cycle through its travel before any other springs other than the ssd spring compressed
im still sending them out of service and a revalve/repsring
but just thought somebody wanted to know
i also have a question about the ssd spring
i have it set so when i lift my front end up, there is about 15inch of clearance on the front of my quad, and when i push it down with my hand, it sags down to about 13 inches before the springs reach a point where they can compress and rebound
is this ok? or should i tighten my preload ring a lil more, so it only sags about an inch instead of 2
sorry, im a little unclear on what that sag spring accually does, can someone explain it to me?
well, it was a simple fix, i have the spring crossover peices on upside down, and it made the shock fully cycle through its travel before any other springs other than the ssd spring compressed
im still sending them out of service and a revalve/repsring
but just thought somebody wanted to know
i also have a question about the ssd spring
i have it set so when i lift my front end up, there is about 15inch of clearance on the front of my quad, and when i push it down with my hand, it sags down to about 13 inches before the springs reach a point where they can compress and rebound
is this ok? or should i tighten my preload ring a lil more, so it only sags about an inch instead of 2
sorry, im a little unclear on what that sag spring accually does, can someone explain it to me?