need help

[250r rider 88]

I CANNOT get my chain side hub off of my axle for nothing ive tried evrything except cutting the axle nut any ideas on what to do ive put a air gun at 120-130 psi to it and still no luck help me please

[xlr810]

1- remove the rear wheel

2- remove the cotter pin

3- have someone holding the rear brake lever

4- Go after it with a big breaker bar

Good luck

[lee37vernon]

when he says BIG breaker bar .. thats what you need , mine took a 1'' bar that was 5 feet long , i happened to live near a gearbox rebuiders and it was there's . a proper snap on windy gun would not touch it with heat , wd 40 nothing .. needed brute force and a real big lever
and it was off bike by the way , in the biggest vice i've ever seen too ..

[250r rider 88]

ok i will try that mine is off the quad to so ill need abigger vice than mine thanks

[bananas]

Your might need to heat it up and use the breaker bar...

[250r rider 88]

this was an intersting night i tried to use a breaking bar iwith this thing tight as h**l in my vice when i went to pull up it tore the vice out of my workbench LOL remounted it and it did it again neighbor has a better vice i will try tommorow