TheBlasterMan
02-08-2006, 04:43 PM
I am going to trade my blaster for pretty much anything that is an improvement. Im interested in banshees, 400s, 450s, and raptors. Id add some money just dont know how much.
These pictures are old, maybee 8 months, but little has changed. I replaced the Rear axle carier and axle along with the barings. the engine is bored .050 over with wisco piston, topend was replaced about 2 years ago. The rear brake caliper needs replaced, could use a new throtle cable, front left fender is cracked from a small tree, and it leaks a little oil, not 100 percent sure from where, i beleive the shifter lever area. It needs 2 bolts for the front brakes to be operational and a nut for the swing arm bolt, it vibrate off. I havnt rode it much due to it not havning brakes so it in good condition for a 1993. For a little money this can be a nice fun project quad.
1993 yamaha blaster
Tusk Nerf Bars
Ricochet A-arm Skid Plates
Ricochet Swing Arm Skid Plate
Ricochet Chassis Skid Plate
Bored .050 over
Some kind of aftermarket clutch (not sure what kind)
Uni Air Filter
Maxxis Razr Rear tires
Maxxis front pro tires
VITOS Oil injecton Block off
NEW Front and Rear sprockets along with chain
Here are some pictures:
http://img154.exs.cx/img154/4388/im0001101yj.jpg
http://img154.exs.cx/img154/6194/im000110a0kp.jpg
http://img154.exs.cx/img154/3249/im0001112qd.jpg
http://img154.exs.cx/img154/3027/im0001126ue.jpg
http://img154.exs.cx/img154/2968/im0001133pa.jpg
I am located near pittsburg pa.
These pictures are old, maybee 8 months, but little has changed. I replaced the Rear axle carier and axle along with the barings. the engine is bored .050 over with wisco piston, topend was replaced about 2 years ago. The rear brake caliper needs replaced, could use a new throtle cable, front left fender is cracked from a small tree, and it leaks a little oil, not 100 percent sure from where, i beleive the shifter lever area. It needs 2 bolts for the front brakes to be operational and a nut for the swing arm bolt, it vibrate off. I havnt rode it much due to it not havning brakes so it in good condition for a 1993. For a little money this can be a nice fun project quad.
1993 yamaha blaster
Tusk Nerf Bars
Ricochet A-arm Skid Plates
Ricochet Swing Arm Skid Plate
Ricochet Chassis Skid Plate
Bored .050 over
Some kind of aftermarket clutch (not sure what kind)
Uni Air Filter
Maxxis Razr Rear tires
Maxxis front pro tires
VITOS Oil injecton Block off
NEW Front and Rear sprockets along with chain
Here are some pictures:
http://img154.exs.cx/img154/4388/im0001101yj.jpg
http://img154.exs.cx/img154/6194/im000110a0kp.jpg
http://img154.exs.cx/img154/3249/im0001112qd.jpg
http://img154.exs.cx/img154/3027/im0001126ue.jpg
http://img154.exs.cx/img154/2968/im0001133pa.jpg
I am located near pittsburg pa.