i gotta problem.....

[bobbys9350]

ok just got my new TRX and rode it for about 30 minutes. brought her home and parked here in the garage..... well knowing me i got to checking out the bike and thought oooo, lets take the spark arrester otu and see what it sounds like! i pulled the end piece off and then pulled the arrestor or baffle out. then when i went to put the end piece back on the top screw went in fine, then the other two didnt. one it just got tight all of a sudden and would NOT move no matter how i tried, i eventually had to snap it off in the silencer. the other just wont go in unless i force it and will prolylbreak off too. what should i do? just tap the holes and die the bolts? thanks!

[GoOn3]

buy aftermarket slip on exhaust.

[JW450R1]

hmf full system time,and jet kit.

[wanta450]

maybe you could try a little oil on the screww first:rolleyes: :confused:

[aroracer72]

Save up and get a full pipe. But i had this problem...you hav to evenly tighten the bolts in sequence....otherwise they'lljam, and eventually, break off.
CHAD

not that big of a deal man...either leae it with spark arrestor off or get a slip on

[dtmichau]

I had this problem too. All I did was buy the LRD full system, Stage II cam, Jet Kit, KN, Kenda Klaw Tires, and a cool looking graphics kit and my problem was fixed.

[bobbys9350]

Thanks guys, an aftermarket kit and many other mods will son be coming for sure, but im only 16 and had my parents take out a loan and spent over7k yesterday, lol. if i leave it you how will i have to jet it? thanks!

you do not need to rejet if you only take the end off. if you take the lid off or cut a whole in the lid be prepared to rejet

[bobbys9350]

well i took the end cap off then the spark arrestor out. do i need to rejet and is it fine like this to finish breakin it in? thanks a lot

Originally posted by bobbys9350
well i took the end cap off then the spark arrestor out. do i need to rejet and is it fine like this to finish breakin it in? thanks a lot ya hur fine man...no need to rejet

[yamablaster24]

when iwas takin mine out the first one snapped right off, I drilled it out and put a nut and bolt through it