what kind of power will i get out of this setup

[Blue250X]

I have a 91 250x and its bored .020 over and has a wiseco high comp piston, it is not running yet, but when it does, will i get bottom, mid or topend power gains?

[xx3003xrdrxx]

a little bottom end , not much to notice tho.

[300ex mxracer]

.2o over doesnt make a whole lot of differance but the piston will give you power all around.

[Blue250X]

Originally posted by 300ex mxracer
.2o over doesnt make a whole lot of differance but the piston will give you power all around.

will i be able to be riding in 2nd gear and just pull up and gas it and pop a wheelie?? or in 3rd or 4th??? just wondering

[Honda TRX250ex]

well mine is bore i forget what that is because im super tired its like 73mm or somthing. well i can pop wheelies in second and third but not fourth. and 4 and 5 the front end is pulling up.

[nakomis0]

Originally posted by Blue250X
will i be able to be riding in 2nd gear and just pull up and gas it and pop a wheelie?? or in 3rd or 4th??? just wondering

that would also depend on gearing.

depending on the condition of the old piston you could be noticing a world of difference w/ the new piston.

[ltz400rider118]

dude just get a bigger quad then there is no doubt about the power!!

[Blue250X]

Originally posted by nakomis0
that would also depend on gearing.

depending on the condition of the old piston you could be noticing a world of difference w/ the new piston.

actually, my last piston was horrible, it was burning so much oil and the rings were so bad. there was a layer of black buildup on top of my piston like maybe .5-1 cm thick. im running stock gearing and might go up to a 14 tooth front soon