electrical help please

[fast426]

ok well i was puttin a new kill switch on my quad, and i went finished and went to start it, and it turned over for a while and then it just stopped. then when i tried to start it nothing happened. after looking it over i found that the fuse was blown back by the battery, so i put a new one in. as soon as i turned the switch to run it blew out again. i tried again with the same result. we jumped the sollenoid, and it runs, but i have no idea where to look for the problem.

thanks
lucas

[Pappy]

re check your ground wire from the kill switch

[fast426]

wow that was fast lol, ill check that thanks

[Pappy]

and if the ground is good, its possible you either hooked the 2 wires up backwards or wired the coil wire to the wrong spot on the coil

[hondajoe05]

Originally posted by fast426
wow that was fast lol, ill check that thanks

they don't call pappy pappy for nothin

[fast426]

i knew he was good, but it couldn't have taken more than 30 seconds lol
thanks again

[fast426]

ok i have another question. I have a pro armour kill switch, and there are 2 wires coming out of it. does it matter which one is which, and could this be my problem.

thanks
lucas

[fast426]

bump