CLutch Cover prob.

[Cr85rRida]

Okay i installed my clutch update kit, but i forgot to label the two holes where the longer bolts go to mount on the clutch cover. Does any one know which 2 holes are for the longer ones?

[D Bergstrom]

Look at the exploded view on servicehonda.com, click on right crankcase cover on the left. The two longer ones are bolt#12.

http://www.servicehonda.com/hard%20parts/atv/trx250r%2086-89/trx250r%20frames%20page.htm

Doug

[jon370r]

Threre are 2 alignmet sleeves for the cover. One toward the front by the water pump and one in the back by the swingarm pivot. The long bolts go in those holes.

[Cr85rRida]

Thank you so much man I appreciate it!

[readybeartoe]

I know you have done this before but just incase you haven't: make sure you do not over tighten the bolts!!! I just cracked my inner case right above the front water pump!!! When I installed a new cover..:ermm: I will eventually weld it but if I could go back again and do it all over I would have torque it to spec and that's it!............ "Just, Just more one turn---SNAP!-

[Rich250RRacer]

Keep this in mind because it holds true for ALL Honda motors and usually every other brand, slide all the bolts in their holes and they will all stick out the same distance. If one is in or out too far, it is the wrong hole.

[Cr85rRida]

yeah thanks for the advice. I installed a duncan quick change cover so if that snapped boy would i throw a fit.:)