levers?

[ImWhite]

ok well i finally got off my *** and put my lsr pb blockoff on this morning
does any1 use stock levers and perch after this?i thought about putting spacers in where the pb thing was on the lever in the empty space,would this work fine?thanks for help

[Chino886]

I am going to say no....but I don't know that for sure.....

[xc_racer1]

it would work like ive seen ppl do it
but i dont recomend it b/c ur kinda defeating the purpose
the point of taking the parking brake out is to get a new clutch
if ur gonna get one id go with the msr raptor shorty
i have one on mine and its smooth as butter
way easier to pull than stock
but itll rack u about 50 bucks

[400exmkt]

i ordered mine from golden west cycle
it was like $29 with perch, lever, and block off plate

[xc_racer1]

Originally posted by 400exmkt
i ordered mine from golden west cycle
it was like $29 with perch, lever, and block off plate



you gotta d*mn good deal then

[400exmkt]

http://goldenwestcycle.net/tek9.asp?pg=products&specific=jofngqr0



There you go.

[Rip_Tear]

I'm just using the stock clutch, I left the little parking brake bit in there for a spacer. I'd rather spend some money on other "more functional" parts, all the little "cheap" parts add up too, I'm leaving the stock "block off" on there for now too. I'll get around to getting the little pieces.

[ImWhite]

thanks guys but since i alread yhad the blockoff,all i needed was a new purch!not even 10 bucks,picked up a msr 1 from my shop,looks good and working good so far!thanks again