Removing Stem bearing

[shogun_98]

Anyone know what the best way is to remove the stem bushing?

[Pappy]

find a large bolt that has a head the same size as the inverted nut. weld a nut or double nut it and use it to remove the nut and bearing.

i hope that made sense:p

[jltld]

I think it is close to 30 mm. You can use an old rear hub nut from a 250r, it just happens to be the same size.:)

[shogun_98]

Thanks for the replys I think I have an axle nut laying around i'll have to check

[popo]

Just an FYI. Your gonna need a good heat source applied to that area. Because Yam used mega-ton locktight.

The bearing pushes up from the bottom of the frame rather than down, once the seal is removed.

[jcline]

How do you get the oil seals out, top and bottom?