dsaint77
01-13-2006, 11:33 AM
Hi,
I have a 1987 honda 250r with some front brake problems. I have drained the brakelines, changed the pads and cleaned up the calipers as much as possible without pulling out the pistons, and I still have sticky brakes. The brakes do there job and stop the thing but they drag. After I push the pistons back in the hubs and rotors turn fine but when I apply the brakes they stick afterwards. I am not sure if I should pull the pistons out and rebuild them or not, or if it is the master cylinder.
Any info or help would be greatly appreciated.
Adam
I have a 1987 honda 250r with some front brake problems. I have drained the brakelines, changed the pads and cleaned up the calipers as much as possible without pulling out the pistons, and I still have sticky brakes. The brakes do there job and stop the thing but they drag. After I push the pistons back in the hubs and rotors turn fine but when I apply the brakes they stick afterwards. I am not sure if I should pull the pistons out and rebuild them or not, or if it is the master cylinder.
Any info or help would be greatly appreciated.
Adam