REapplying graphics

[USAF Dirtboy]

Ok here is my question...about a month ago i put a graphics kit on and everything was put on great. but one time i let someone wash it for me( which i will never let anybody do again ), and a couple of corners on the graphics are peeling. It is only about a inch at the most but some sand got in there. How can i fix this, I know somebody has this happened before, and really dont want to buy a new kit....Please help me ou with this!!! :(

[signboy]

you can try a thin double sided tape. I'd cut the piece that is not sticking off. Maybe round it off if its on corner. It won't look the best but should prevent the rest of them coming off.

[USAF Dirtboy]

i thought about that, but is there some kind of glue or spray i can use

[xNOILABOYx]

check dennis kirk they have that"sticker off"and"sticker on"stuff

3M spray on adheasive.

[USAF Dirtboy]

have u tried it...if so give me some tips please

[signboy]

I don't think spray adhesive will hold it. If you do try it, I'd mask it off to prevent getting it where you don't want it.

[awsomeaussies]

I've tried the spray adhesive before. It worked pretty good. When you spray it, take some duct tape or something and tape it on after you spray and wait a day and peal the tape off:) but carefully;)

[luvmyex]

just trim it off if its not too bad

[infantry317]

Originally posted by MXFourTwoEight
3M spray on adheasive.

3M Super77 spray-on, you could probably dab it onto corners with a q-tip. I took off # plates, sprayed it on them and put them on another set of plastic, they never came off.

[prepracing]

Originally posted by MXFourTwoEight
3M spray on adheasive.


works great :macho