400ex Chains and Sprockets

[Craig02]

I have a 15 and 16 tooth sprockets. 1 stock chain and 1 used DID chain (sold) with masterlink. I also have a case saver for use with the 16 tooth sprocket. I will take $25 shipped for all of this. 14t sprocket is sold.

[Craig02]

Chains

[badtothebone440]

are these chains and sprockets in pretty good shape? not worn much?

[Craig02]

They are used parts but not worn out, you can see from the pics that the sprockets have a lot of life left and the chains are in decent shape also

[badtothebone440]

Alright I'm interested then ...I understand they won't be perfect but if they have a lot of life left in them then I'm not going to worry about it. What size is stock sprocket and chain? 16 tooth?

[badtothebone440]

you dont have a rear sprocket? I need one of those too

[Craig02]

Stock gearing is 15-38, I just checked and I do still have a 36 tooth rear sprocket.

[badtothebone440]

Well if stock rear is 38 then that's what I need because I think mine is a tooth down and I'm trying to go back to stock. I'd like to buy it as a set but I can't really do it without a 38 rear sprocket, sorry man.

[Craig02]

You could run a 14-36 which would be close to stock gearing.

[Craig02]

DID chain is sold will take $25 shipped for the rest.

[Craig02]

ttt

[400exrules]

ohh, hey i just bought a DID chain and i cant figure out how to get the masterlink together. how did you do it? i put the connecting piece with the two shafts, through the holes, then i put the washers over the shafts and try to put the plate on, so and then put the snap on clip over that, but it will not snap on, wtf. is their a trick to it? do i need to mash the plates together to squash the o-rings so i have room for the clip...????

please help

[Craig02]

Originally posted by 400exrules
ohh, hey i just bought a DID chain and i cant figure out how to get the masterlink together. how did you do it? i put the connecting piece with the two shafts, through the holes, then i put the washers over the shafts and try to put the plate on, so and then put the snap on clip over that, but it will not snap on, wtf. is their a trick to it? do i need to mash the plates together to squash the o-rings so i have room for the clip...????

please help

Put 2 orings on each side of the chain, and you may have to use some pliers to squeze the masterlink to put the clip on which may require a hammer and screwdriver to knock on.