How Put Whole Axle Assembly Together

[hondapro300EX]

JUST CONFUSED ON WHAT TO DO FIRST. OR NOT TO TOUCH FIRST.

REALLY NEED SOME HELP PLEASE!!:confused:

[WhiteZee]

buy a service manual.

[XCRACER26]

Just do like I did and take it apart ,and remeber how you put it together, thats the best way, if your looking at the quad from the rear start from the left and make your way over to the right

take the hubs off first, then take the axle lock nut off( rememebr reverse threaded), then undo the chain and then pull it off towards the chain side

[prepracing]

assuming this is a stock axle Looking at it from the rear, 1st, take right wheel and hub off. 2nd loosen axle lock nut ( the larger diameter nut first, it will loosen going towards the swingarm ) then loosen the smaller nut going the same direction untill you see a large C- clip that is under the nut ( you can stop lossening when you get to this). Take clip off using screwdriver or snap ring plyers. 3rd lock nut assembly will slide off. 4th take brake caliper off, then brake rotor should slide off ( it may take some light pecking from a hammer/rubber mallet ) to slide off. 5th there will be a large snap ring holding the brake caliper plate against the swingarm, take this off ( then plate will come off ). 6th loosen the 4 carrier/chain adjustment bolts all the way. 7th take chain off. 8th axle will pull thru from the left side of swingarm ( carrier may come out with axle, if not you can pull it out next ). Reassembly in reverse order.....Goodluck :macho