View Full Version : +2 or +3 axle...need advice.
thomps6s
12-21-2005, 10:08 AM
I am putting +2 LSR a-arms on my 400ex. I found a LSR +3 axle for $220 shipped. Will this be an okay setup or should I hold off and get a +2 axle? I realize the difference is only an inch between the two, but I am kinda a noob with the aftermarket setups, any help would be appreciated.
well i think stock a 400ex is 43 inches wide up front so + 3 a-arms on a 400ex would be better than +2 cuz i dont think +3 makes u over 50inches on a 400ex but not for sure.
wider is better jest cant b over 50 inches for racing.
Chino886
12-21-2005, 11:01 AM
if it is an LSR, it is probably adjustable.....my LSR axcalibur is adjustable from +2 to +4....
oops i thought he was taklin about the a-arms. i have that axel and its still not broke
thomps6s
12-21-2005, 11:38 AM
The axle is adjustable form stock to +3 with the spacers.
The spacers are 1.5 inches each.
Chino886
12-21-2005, 11:42 AM
yes that is a good set up...I am sure you will notice a big difference....
bwamos
12-21-2005, 11:52 AM
Yup, grab the axle. They are adjustable with the spacers as the others have said.
thomps6s
12-21-2005, 01:00 PM
I know it is adjustable with the spacers. The spacers are 1.5 inches each. So it is either stock or +3 no in between.
So +3 in the back and +2 in the front will be a good setup? It won't be too fat in the back.
Chino886
12-21-2005, 01:02 PM
I am sure you will be fine, if you have 3:2 offset front wheels, you will be wide....
I am at +4 in the rear and when I put the 3:2s on my +2 arms, I think it is about right.
jwick07
12-21-2005, 01:17 PM
I run the +2 lsr arms and +3 axle with stock off set hipers I really like it.
thomps6s
12-21-2005, 01:34 PM
Yeah, I think i will scoop it up. If I don't like it, I am sure I could order 1 inch spacers.
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.