how do you jet a edelbrock carb?

[30ex-man]

also will it run good with a pipe and a air filter and what power gains am i looking at?

[ky300ex]

The Edelbrock carb is preset from the factory for running a pipe with airbox modifications so it should be somewhat close.The Edelbrock carb doesn't come with jets,it comes with 3 needles and you adjust the needle position up or down by turning a screw on top of the carb.The screw "clicks" by a quarter of a turn,4 clicks being 1 complete turn.If the screw has been turned all the way in or out and the carb still isn't right,then you will need to go up or down a needle size.Tricky at 1st,but once you get the hang of it,it isn't too bad at all.

As far as power gains out of quad with just a pipe and filter i don't really know.I ran the Edelbrock carb on a 330 Sparks motor and loved it.I was running a mikuni 32 mm flatside carb and the Edelbrock seemed to outperform it.