How to get rear sprocket on????

[Fast-n-Furious]

My new sprockets should be here tommorrow or the next day and I was wondering how to put the new one on the rear. I already messed with the mount a little. How do I get the mount off the axle? Do you just tap it with a hammer so it slides out of the grooves or what. Please help anything would be better than what I know about it right now. Thanks.
Ryan

[honda250xrider]

there should be srews on the sproket to the sproket hub take these screws out then take the tire off then there u go that is it ... pretty simple! wait you gotta take the chain off the sproket to

[Fast-n-Furious]

i dont think that will work cause the sprocket mounts on the right side of the sprocket hub(side toward the bearing carrier) and you have to take the whole hub off to get the sprocket off and put the new one on.

[honda250xrider]

just take the bolts off then turn the sproket to make it fit through the sproket hub u might be right u might not be able to do this i am just going with my 250

[Fast-n-Furious]

i'll have to check it out when i get my sprockets in but if anyone has a 400 and knows how to do it on one i'd really like to know

[honda250xrider]

just look in the picture at the sproket hub and the sproket take the bolts off then u turn your sproket so it will fit around the sproket hub

[Fast-n-Furious]

thanks for the help ill give it a try when i get my new sprockets

[nakomis0]

Just like 250xroder said.

Take the bolts off holding the sprocket. and then take the sprocket off.

The sprocket is made so tthere is room to slide it over the sprocket hub