reichart90
11-13-2005, 08:10 AM
i posted last week about thinkin about a 440 kit. i've heard of problems with them and cooling issues. my 400ex already has a 416 kit (installed by previous owner). i want to make this thing have snappier throttle response. i've been lookin at these edelbrock carbs (for the 400ex stock/slightly modified). i would assume it cant be that difficult to install the new carb. would i have to mess around with jetting at all? all of my mods are in my sig. i've never messed around with atv carbs... but i think i can figure it out. the whole setup seems simple.
the note on the bottom of the edelbrock website is this:
"All carb kits are pre-jetted on stock motors with open/modified air box, aftermarket exhaust, stock ignition, and 91 octane fuel at 1500 ft. elevation unless specified."
as per that statement... i shouldnt have to mess around with jetting at all right?
your help is greatly appreciated.
the note on the bottom of the edelbrock website is this:
"All carb kits are pre-jetted on stock motors with open/modified air box, aftermarket exhaust, stock ignition, and 91 octane fuel at 1500 ft. elevation unless specified."
as per that statement... i shouldnt have to mess around with jetting at all right?
your help is greatly appreciated.