heims into the spindle....

[brandon250r]

The studs that go into the spindle and then connect to the heim. Do i need to press these into the spindle? or can i heat up the spindle a little and tap them into place?

any recommendations would be appreciated thanks!

[TBD]

Originally posted by brandon250r
The studs that go into the spindle and then connect to the heim. Do i need to press these into the spindle? or can i heat up the spindle a little and tap them into place?

any recommendations would be appreciated thanks!
I believe that you put them into the spindles and then install the nut and tighten. The pin is the samething as your ball joint so treat it the same way.

[brandon250r]

yeah i was thinking it was gonna have to press into the spindle like the stock ball joint did...got it though thanks for the reply! :)

now its time to dial in the alignment :)