cam to wake my R up

[T-MAC 450R]

i have a 05 450r with a HMF full pipe kit with UNI filter. witch cam would wake up my mid to top end better. find the HRC kit cam on ebay or buy a hotcam stage2? and while im putting the cam in should i put the piston in? i will also be running the air box eliminator too. and what would be the proper jet size? or will i have to play around with them?

[watts16]

im going for stageII

[JRP]

id go with the hot cam stg 2. thats what i got

[cals400ex]

the stage 2 will be more user friendly at lower rpms. the hrc will rev a little higher. the hrc is as quiet as the stock cam where the HC is a bit louder.

[04'400ex'er]

Originally posted by cals400ex
the stage 2 will be more user friendly at lower rpms. the hrc will rev a little higher. the hrc is as quiet as the stock cam where the HC is a bit louder. so the STG II is more of a torque cam with a mid range hit and the HRC is more of a top end hp pulling cam?

Originally posted by 04'400ex'er
so the STG II is more of a torque cam with a mid range hit and the HRC is more of a top end hp pulling cam?

stg2 HC improves everywhere and a lot on the mid-top, while the HRC doesnt improve on low end at all, and puts all the power from high mid-top

[T-MAC 450R]

can the stage 2 cam just drop in fine inplace of the stock cam with no mods?

[JRP]

yea it is a drop in cam.. i have a stock engine and i will jus drop it and it wil lbe fine.