PDA

View Full Version : Laeger XC 250R



GNCC Laeger 250
10-24-2005, 05:49 PM
Laeger TRX 250R set up for Cross Country Racing. Many new parts & many many extras. Laeger frame, swing arm, a-arms steering stem, & tie rods. Ohlins shocks, Hinson, PRM, IMS, & PRM. Cases, crank, bearings, counter balancer & Tranny all new this summer. This bike has many GNCC wins & three championships. GNCC National #33 - Blaine Shick
$6000 takes every 250R part/piece I own. If seriour please post.

Blaine Shick

GNCC Laeger 250
11-17-2005, 03:26 PM
Not much on this not new or almost new. Cases new this summer along with 2, 3, 4 & 6 gears. New Crank, Counter Balancer & fresh top end. Comes with almost another complete motor. Lacking just a few minor parts. Extra shocks. Steeing stem, Axle, Plastic, etc.........have photos available upon request........$5000 for everything............Located in NW Pa.


Blaine

snapon
11-17-2005, 07:06 PM
please send pics to me at GregLor15@hotmail.com

what year frame is it?
T-Pin front? Long Travel?

I Live in NY so pickup wont be a problem.

snapon
11-19-2005, 08:49 AM
???????

GNCC Laeger 250
11-22-2005, 04:44 PM
Sorry about not getting back to you sooner. I did send you your request. Please let me know if anything went wrong.

Blaine

Acello
11-23-2005, 12:39 PM
could u send some photos to Mikeacello@hotmail.com
Thanks.

addictedtomud
11-23-2005, 08:50 PM
Please send pics to kyonak@earthlink.net
Know anyone who wants to buy a YFZ?
I live about an hour from you-near wheeling, WV
Thanks
Kyle

GNCC Laeger 250
12-03-2005, 09:06 AM
Photo

srfootball50
12-03-2005, 01:34 PM
is the engine bored out at all or is it stock bore looks like an awsome R

schiavo250r
12-03-2005, 01:56 PM
Is this a protrax front end, cr 500 link, long travel? What year is the frame? Also can you email me pics of the bottom of the frame. My email is schiavo250r@aol.com. I live in CT so pickup is not a problem.

Jim

GNCC Laeger 250
12-04-2005, 08:33 AM
The frame is a 97 stock replacement Laeger w/ the stock Honda rear linkage. The linkage was replaced in late 2003. The shocks are also stock length. The front spindles are 89 w/ Nac's hubs. I have (2) 250 cylinders that are both .050 over with V-Force reeds & both have exhaust flanges. Both have about a half a season on the bore & the piston has about 2.5 Hrs on it. The clutch is also new.

I have many many extras: Welded repaired cases, crank, almost a complete gear set, cylinder w/ V-Force reeds, clutch basket, two gasket kits, clutch plates, swing arm bearings/seals, water pump seal, Older fresh Ohlin front shocks, shock parts, nurfs, pegs, bumper, rear grab bar, skid plates, spindels, hubs, radiator, axle, good Honda plastic (fronts 1 year old), Laeger steering stem, complete air box, & LRD silencers. I'm sure I forgot some stuff.

Blaine

srfootball50
12-12-2005, 07:13 PM
how much would it be without all of the extra parts

GNCC Laeger 250
12-26-2005, 05:06 AM
I can't go below $4500.


Blaine

skyhigh716
12-26-2005, 11:22 AM
let me know if the extra leagers stem is in good condition(chrome) and what you would take shipped for it? could you also send me a pic at FatLr9@aol.com

Dustin

JMaN05
12-27-2005, 07:06 AM
interested in a trade :) :)

GNCC Laeger 250
12-27-2005, 01:11 PM
I'm not interested in any trades & really would like to sell as whole bike without parting out anything but?


Blaine

GNCC Laeger 250
12-28-2005, 03:17 PM
Seriously considering parting this out.........nyone interested? Sad day!!!!!!!!


Blaine

trx400exxracer
12-28-2005, 09:43 PM
Originally posted by GNCC Laeger 250
Seriously considering parting this out.........nyone interested? Sad day!!!!!!!!


Blaine

does the 250r steering stabilizer fit on a 400ex if so I am looking for an aftermarket steering stabilizer

Rich250RRacer
12-29-2005, 09:58 PM
Hey Blaine, Rich Yaslik here, are you getting something new or are you getting out of racing altogether?

GNCC Laeger 250
12-30-2005, 02:07 PM
Hey Rich...........Interested in another R? Probably getting something else.........Have not made up my mind yet.......Need any parts?


Blaine

Rich250RRacer
01-01-2006, 01:52 PM
If I hadn't spent so much money this winter, I probably would have taken you up on the quad. Hopefully you can sell it whole, whoever gets it will get one hell of a quad. I hope you stick with racing, maybe get that Vet class championship again. I don't know if I'll see you at the GNCC's this year, it's getting alittle expensive. If I don't run those, I'll probably run AWRCS.

GNCC Laeger 250
01-02-2006, 03:02 PM
Sold!!!!!!!!

Thanks for everyone who inquired about my quad. It went to South Eastern Pa. & I probably won't see it again. Very, very sad that the best quad ever made is coming to an end. Money, sponsors & promotors make it almost impossible to keep them in racing. To all you loyal 250R fans, keep them alive and maybe... Someday Honda will bring them back..........................

Sincerely
Blaine Shick