Ab****

[oj250r]

I those bushings,sleaves or whatever they are called that go in the swing arm for the swing arm and the one on the right side wont go in all the way...remember when you told me i had to cut one of them or something,,well is that the one im suppose to cut??heres a pic to so you what im talkin about..

pull the bushing back out and make sure that a needle bearing hasn't came out. Try putting the bushing in from the inside too.

[oj250r]

the bearings did not come out or anything..i think they are just to big and the spacer go cause of it...

[oj250r]

help anybody....please

I wish I were there to know exactly what your talking about!

[oj250r]

i think the needle bearings in the swinger are to big cause the sleeve will go in until it hits the last bearing and then it wont go anymore...if you want i'll send iot to you and you can fix it...

that's no problem, let me know.

HaHa. I got your main bearings and seals in yesterday and your case half and gears are on there way. You better whip some butt next weekend if I get the parts in on time!

[oj250r]

Originally posted by ab****
that's no problem, let me know.

so do you want me to ship it to you so you can fix it?? if so,,how much is it gonna cost and can i send the motor bushings also so you can cut them for me??

The only thing I will charge is for shipping and any parts I need to install. I need you to mark the bushings where they need to be cut at EXACTLY. I'll keep an eye out for them.

Originally posted by roostin_dale
no no no, its not "IF i get it done"....its "WHEN i get it done"

and no worries, i will kick some butt. Give me a call sometime tomorrow, i want to talk about some ****Tech Graphics...I will have blue fenders and black frame next year and i need some graphics to go with it! (dont tell Troy about my colors)

What time do you get out of school and I'll give you a call then? I have complete graphic kits in the works, but I'm still up in the air on the exact design. I'll PM you the link to what I have so far.