looking for a 250R cylinder

[LT250Racer609]

im looking for a big bore 250R cylinder....doesnt matter what size

looking for a 265 or bigger

[zedicus00]

ive got a big bore 310, stock resleeve with MAD portwork done to it and a milled head, comes with piston, rings and everything to be a bolt on kit. also its broken in and ready to run. on last bore but comes with a new sleeve. AND EVERYTHING has been CRYOED so it will last a long time on this bore.

its got about 400$ worth of porting done to it, comes with brand new, also cryoed, replacement big bore sleeve, good piston kit with rings, pin bearing and clips. i would give u all that stuff for 650$

heck ive got the prted aluminum intake, a custom v-force-3 reed, and a 38mm A/s kehin carb i will sell too for an extra 300$

this is the most power a stock cylender can make short of nos, and its set up as a shortrod motor so if u hav an 87 or newer crank yull need a spacer plate and studs and stuff...

also its 200lbs psi. so mix sum race gas with yur pump gas, it may run on 93 octane alone but i never tried it.