View Full Version : compression
Raptorider660R
10-02-2005, 06:18 PM
when i try to turn over my raptor there is to much compression then when i take the plug off it turns over perfectly wat could be the problem
Specialist
10-02-2005, 07:01 PM
Your Valves aren't opening enough to allow the air out most likely. Adjust your valves and see where that takes you.
Raptorider660R
10-02-2005, 07:19 PM
i did it with the cylinder head off
Specialist
10-02-2005, 07:53 PM
You Adjusted your valves with the head off??
If yes then make sure ur timing is correct..
Raptorider660R
10-03-2005, 06:43 PM
ok this is wat i did took apart engine built everything again then adjusted valves try to start raptor turns over a few times then it gets harder to turn over got to keep hitting start botton then i took the plug out turns over easily but then if i put the plug in it turns a few times then after that i have to use forceto turn it over
TheRidinLife01
10-04-2005, 02:25 PM
timed wrong
lzyga05
10-08-2005, 09:46 AM
yep prob ur timeing or ur messes up ur cam becuse rap cams have a auto decomp thing in them it only starts working when its low rps (very low)
jared_scarboro
02-22-2006, 08:07 PM
i have the same exact problem right now need help
lzyga05
02-22-2006, 08:08 PM
timeing!!!!!!! is of ... read the manual better
jared_scarboro
02-22-2006, 08:10 PM
i checked the timming and its good!!!!!
lzyga05
02-22-2006, 08:12 PM
..... um bad batt
jared_scarboro
02-22-2006, 08:13 PM
put a brand new 1 in it and how could the timming be messed up i havent tampered with it?
lzyga05
02-22-2006, 08:14 PM
... ur timeing could slip .. very small chace of that happening but ... it might be it :)
jared_scarboro
02-22-2006, 08:15 PM
could it be the valves?
lzyga05
02-22-2006, 08:16 PM
if ur motor turns over then u didnt drop a valve, but .. idk i would have to take a look in ur head ... sry if i cant help u
jared_scarboro
02-22-2006, 08:18 PM
1 other thing could it be the compression release on the cam?
lzyga05
02-22-2006, 08:19 PM
... are u talking about ... like the auto decomp for starts? ... idk the proper turm for that
jared_scarboro
02-22-2006, 08:20 PM
yes that
lzyga05
02-22-2006, 08:23 PM
yes it could be that ... but i think if that doesnt work, u can prob push ur quad down a hill and pop in it to 3rd and it should start , or have a friend pull u.
jared_scarboro
02-22-2006, 08:25 PM
i tried something like that i pushed it as hard as i could and jumped on going down a paved road put it in 4th and let go of the clutch the back tires locked up
Powered by vBulletin® Version 4.2.1 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.