PDA

View Full Version : Best silencer


rockman
10-02-2005, 12:54 PM
Ok guys what would be the best silencer for a paul turner mid with a mild mid port?
YFZRob
10-02-2005, 03:25 PM
I am very pleased with my FMF Turbine Core 2. I have to run a sparky where I ride, so I ditched my ESR silencer for the FMF. The ESR sounds MEAN! When I had my ESR 310 kit, it screamed and sounded incredible. I swapped to the FMF and it wasn't as angry sounding, but still very nice. It's a good compromise of sound and performance. Plus, I like that the FMF uses two rubber mounts instead of the rigid bolt on mounting of the ESR.
ground_zero298
10-02-2005, 04:20 PM
My engines stock and I had to get a sparky also. I also have a FMF Turbine Core 2 and I noticed no difference between this and my power core. Actually does anybody now of any high performance silencers with a arrestor in it? Also I've seen those adapters on ebay that slip over the rear of you silencer, they look awful consticting anyone tried one?
Jester
10-02-2005, 04:57 PM
I went from a power core to a turbine 2 Q for the sound restrictions and sparky...

I run woods with a 265 ported for low end, and I did notice a difference, but it was minimal.
ground_zero298
10-02-2005, 05:07 PM
Is the Q much quieter than your power core?
Jester
10-02-2005, 06:02 PM
it is, kinda hard to explain. at Higher RPMS, which we are at all the time, NO, but at lower, it is.

I don't care for it cause of the length. it sticks out past my grab bar.

http://alldigitaldirt.com/250R/sept905/image001.jpg


you can see it in this pic. that is my registration plate for Pa on the grab bar.
machwon
10-02-2005, 06:13 PM
The best silencer is a paul turner. Unless of course you need a quite one. Then use the power robbing FMF stuff.
BLACKeR
10-02-2005, 06:17 PM
The best silencer is a paul turner. Unless of course you need a quite one. Then use the power robbing FMF stuff.

yep, use the PT fat boy. if noise is an issue use a turn down end cap.
ground_zero298
10-02-2005, 06:23 PM
Do you need a red flag on that to ride it?:eek2:
rockman
10-02-2005, 06:41 PM
yep, use the PT fat boy. if noise is an issue use a turn down end cap

ya my gf's brother has a fat boy on the pt and it sounds damn good, thats what i was going to go with i was just wondering if there was anything else out there worth looking at. thanks guys!!
TheIceMan
10-02-2005, 07:19 PM
posted by BLACKeR


yep, use the PT fat boy. if noise is an issue use a turn down end cap.

agreed ,or Sparks
CHAR250R
10-02-2005, 07:30 PM
Originally posted by BLACKeR
yep, use the PT fat boy. if noise is an issue use a turn down end cap.


^^^
What he said!!!