PDA

View Full Version : 450R ELKA/PRP Front End -- FOR SALE!


RedRacer44
09-30-2005, 10:31 PM
I have the following parts for sale off of a 2004 450R. Prices are without shipping included. I use PayPal preferably...

Elka Triple Rate Front Shocks w/ Remote Rezzies (Compression adj. only) -- $650, freshly revalved (190lb rider, MX) w/ new seals and oil

PRP Racing Standard Travel +2 +1 A-Arms (PCed Red) -- $250, comes with ball-joints, tie rods, and bushings/bearings

Will sell seperately as described above......or will sell as a package deal for $800 shipped!!

This is a STANDARD TRAVEL front end, not LT sorry :rolleyes:

PM me or email me at redmxracer44@yahoo.com.....

Here is the front end on the bike......
Over-land 450r
09-30-2005, 11:38 PM
who makes the a-arms?? thANKS
kazpr
10-01-2005, 12:29 AM
PRP Racing
RedRacer44
10-01-2005, 09:39 AM
PRP Racing which is Porter Racing Products. Dave Porter has been in ATV racing for a long time and has won a few championships in his time. The guy makes good stuff, I had a similiar front end on my 250R and it worked really well.

PRP builds pretty much everything....frames, a-arms, swingarm, stems, seat latches....etc etc!

Good stuff!
RedRacer44
10-03-2005, 10:49 PM
BUMP! Still have parts for sale!
xsr_racing28c
10-04-2005, 11:08 AM
can you get a closer pic of the construction of the arms.. i wanna compare to my burgards to see if the PRP ones are nicer
RedRacer44
10-04-2005, 11:55 AM
I'll snag some pictures tonight of the a-arms. I'll have to buy a new balljoint for one of the lower a-arms cuz it was in bad shape but I'll throw it in with the a-arms for the buyer!

I have several buddies that have Burgard a-arms and the PRPs are thicker as far as the tubing n' stuff. The balljoints are way better too. My buddy has replaced all his Burgard balljoints twice now and he's had 'em for less than a year....
R3Concepts
10-04-2005, 01:14 PM
Maiers or Lakers?? Sorry...free bump.
red03400
10-04-2005, 01:15 PM
will the a-arms fit a 400ex..or no?
RedRacer44
10-04-2005, 02:29 PM
Those are Laker Custom plastics, really happy with them except the rear fenders arent as wide as factory or Maiers.....

I dont think the a-arms will fit a 400EX, sorry!
RedRacer44
10-04-2005, 04:54 PM
Here are pictures of the Elkas.....
RedRacer44
10-04-2005, 04:56 PM
another.....
RedRacer44
10-04-2005, 04:58 PM
and another....
RedRacer44
10-04-2005, 04:59 PM
I'm going to have to buy a ball-joint for the other lower a-arms because it was bad. If someone wants 'em without balljoint, i'll knock some off the $$$.....

A-Arms...