Hot Start.....

[redrider311]

hey after i have my bike going and its hot.. when i try to start it again i have no luck.. how should i use the hot start.. should i just keep it pulled in and kick til it starts or pump the lever or do the hot start plus gas etc.. i just need some advice cause ive had nothing but a tired leg after this thing gets hot lol :p BTW its a YZ426 motor


thanks guys,
mark

[ss440ex]

After its hot and been shut off.
Kick it twice if it don`t start pull the hot start knob and kick.
It should start in 2 kicks.
Do not pump throttle when its hot, and your tring to start.
Good luck.

[YZ400EX]

Yes after it is warm they more than likely will not start w/out using the hot start..just pull it out, kick it a few times and it should fire right up and then push the hot start button back in..make sure you never give it any gas though while its wamr at all because it will pump gas in the carb and make it a beast to start.. The only time you should ever give it gas before you start it is when it has been sitting for a day or 2..Then just pump the throttle 2 or 3 times..This just gives it a nice little squirt of gas to get you going, but NEVER do it after it has been running..You will get the hang of this stuff..:D

[ex kid]

check your idle speed as well.