300ex with 450r light

[kmmon1]

all that is left is to change the bars to loose the rest of the top plastic and clean up all the lines and cables. A nicer front bumper will be coming soon. The lights work too.....

[kmmon1]

another

[trX250eXmXr28]

that really looks good!!!! tell us how u did it

[quad janern]

wow! that cool

[Trevor]

post some pice of how you mounted them. that looks realy good

[300exr]

Dayum that looks sick, post some pics of it clean dude

[emaxxjeremy]

oh ya thats a must do.
gotta show us some pics of the mounting

[kmmon1]

I will try to take some pics and get them up, It was easy, all you need is a 450r hood and light, Forget the brackets and the lower hood piece. You have to cut the brace in the front of the 300 off, and remove the stock hood. You have to trim the fenders wider because the light is wider then the stock gap. I took some thin flat bar and made brackets to mount the top of the plastics to the sides of the 450r light. Then I made 2 brackets underneith. It is hard to explain I will get pics. My light came with the bulbs and the plug, so I cut the tail off the light and off the 300 and used a trailer wiring harness to connect all the wires. The fenders are a little loose up front now, but not much different then the way they were. I have had this on since may and have done alot of riding since, it all holds up very well. Look near factory too.

[Trevor]

Why do you need the 450r hood? That looks like a 300 hood just cut to fit.

[kmmon1]

you can not fit the light under or around the stock hood. You need the 450r hood, it is molded nicely around the light. I needed to trim the back of the hood down and make it round to meet the stock plastics. I will get some pics one of these days.

[kfxwizzard400]

shhhwweeeet dude

[quad janern]

when can you post more pics??:D
cant wait to see more;)