raptor gytr exhaust

[04raptor]

i recently pulled the plastic off my raptor to do some much needed cleaning and i have the gytr slip on and i noticed where the pipe passes under the plastic by the air box was melted cuz the plastic lays right on the pipe it wasnt majorly melted has anyone else had this problem?

[tater_kamik]

on my warrior, i have the albe pipe and it melted some of the plastic (but not the airbox) just turn the midpipe a little bit and clamp the hell out of it and it should be fine

[04raptor]

it didnt melt the air box it melted the rear plastic on the inside where the plastic bolts on you cant see unless you pull the airbox out.

[TheRidinLife01]

happend to me, i put that heat tile stuff on the plastic that is very close to the pipe, i also wrapped by airbox with it

[tater_kamik]

my bad, yup, same thing happened to me, i say just cut it out a little bit and see if you can rotate the midpipe a little, it worked for me!

[jmc400ex02]

i cut the in side plastic out away from it so hopefully it help hate for my bike to go up in flames or something