PDA

View Full Version : Sparks Exhaust



Chino886
08-18-2005, 07:57 AM
Has anyone done a Sparks pipe rebuild, I have a X-6 pipe and the end cap is crushed, does anyone know if another companies end cap will work. I have heard that the sparks end cap is welded to the core.

Chino886
08-18-2005, 12:36 PM
come on people, I don't want to pay Curtis over $100 just because of my endcap.

Pappy
08-18-2005, 12:41 PM
it should be held in place by 3 to 4 rivits.

you would have to see if someone could measure the diameter of the silencer to see if an off brand would work or not.

Chino886
08-18-2005, 12:43 PM
Can I just replace the endcap then, someone at Sparks told me I had to buy the complete endcap and core.

DO you know of anyother endcaps that will fit on a Sparks pipe?

Pappy
08-18-2005, 12:44 PM
the core could very well be welded to the end cap, if thats the case then sparks would have the assembly only and not the end cap.

K_Fulk
08-18-2005, 04:23 PM
Could you just cut it off like this one, Or is it crushed a lot worse than this one was.

Chino886
08-19-2005, 06:16 AM
I could probably do that but I did not want it to start rusting because if I cut it the finish will start chipping off.