piston and cam

[300ex mxracer]

this winter i will be getting some engine work done. i think i want a port and polish, piston, and cam. i mostly race mx. mods in sig. i was thinking a stage 2 hotcam, would this be a good one for mx? i was also thinking a je 11.1 piston. is this the highest i can run with pump gas(93) safely? where should i send the head for a GOOD port and polish?

[Chino886]

I don't know if you want to send your head out, but I know someone that can port and polish in MO. He has been racing MX for over 20 years, Mike Burns is his name. Let me know. Great engine builder=good price.

[300ex mxracer]

i am thinkin i want someone close to chicago (i know, complete opposite of my original post)

[Chino886]

Originally posted by 300ex mxracer
i am thinkin i want someone close to chicago (i know, complete opposite of my original post)

no prob, let me know if you change your mind, fast turn around time at my engine builder.

[TRXRacer1]

Originally posted by 300ex mxracer
i am thinkin i want someone close to chicago (i know, complete opposite of my original post) Chicago is a tough area for porting. If I were you I'd get ready to send it out to a differnt area. Maybe put some thought into Chino's guy.

[300ex mxracer]

what about the quad cities area?

[Chino886]

The guy is good, he won't rip you off either.

[300ex mxracer]

ok i think about it. i got a while can my season isnt over till oct. 29. what about a good cam and piston? would 11.1 piston be the way to go to run on 93 octane?i was also thinking a stage 2 hotcam for the quad. good choice or not?