Pro-Design help, Replacing the ignition key??

[4everhonda]

I'm helping out a buddy with a new pro-design kill switch install. I want to completely remove the key and just have the kill switch control the ignition. There are 4 wires to deal with. Black, Red, Black with White stripe, and Green which I think is common ground? There are two wires from the kill switch. What wires do I need to hook where to completely abolish the key switch?

Thanks guys

[quad2xtreme]

I can't help you out much but I do know that if you disconnect the green wire when the quad is running and then turn the key off, the quad will continue to run.

/Jon

[4everhonda]

ttt

[Oldracer#23]

Can someone help with this? I would like to do the same thing.