front brake setup

[TheFontMaster]

Ok well I got the front brake lines on... kinda. I just wanna see how you guys got you lines in, the thing where the lines T is off.


I don't know if that made any sense I think I'm more tired than I think.

[elchankoblanko]

I think I know what your talkin about, and Im assuming your running stock brake lines cause if you are theres a spot on the frame with 2 threaded bolt holes for a bracket that connects the break line to the frame. Check out the pic

[TheFontMaster]

Actualy they are +2 stainless lines on +2 a arms. My problem is that if I run the lines above the frame rail that the top a arms mount to they are too short, but if I make them go under that frame rail then the line hits the frame rail and the T block thing doesn't get close to that little braket to hook up.

[elchankoblanko]

hmmm is there any way that your could zip tie it so it stays in place?

[TheFontMaster]

Originally posted by elchankoblanko
hmmm is there any way that your could zip tie it so it stays in place?

I probably could do that and It looks like thats what I will have to do if I'm going to get it done for Rausch.

[250R-Dee]

I use zip ties in the frame area and aluminum clamps on the a-arms.