86 310

[speedjunkie250]

do you have to run the spacer plate with the 310 kit on a 86 short rod motor.the piston is about the thickness of the spcer from the top of the cylinder at full extension.

[Cr85rRida]

im not sure but yo why dont you settle the frame issue with 250-r-250 ???

[speedjunkie250]

First of all its not your buisness . its between him and i . Were workin in out . Anything else you wanna know.

[Cr85rRida]

yeah you never got back to me aout trading those rotars for the intake boot.

[speedjunkie250]

Sorry bout that been really busy.The guy never got back to me to buy your rotors. did you get what you need.

[Cr85rRida]

yeah i went out and bought a new OEM rotor and intake boot....and im stuck with your 86 rotars...:o

[speedjunkie250]

hey i dont live on the comp.my posts said 86R not 88-89R. you should have checked its not my fault.

[Cr85rRida]

Nevere said it was, but i you said we would work it out then i never heard from you again. THen i herd what happend to 250-r-250 and remeberd. Ah owell i realy hope you too work it out though he is really upset and now is set back a whole bunch because of this misshap.

[speedjunkie250]

yeah inderstand we are really both to blame.i guess that selling a frame for cheap really didnt matter the shape. although i didnt know bout the crack.

[Prey]

if its a kit for the 86 motor, the answer is no, no spacer plate needed unless you convert to a long rod

[speedjunkie250]

thank you. i really didnt think so.