best tool for fenders

[NJ honda]

ive been looking at my 400 and i think it needs cut fenders and i was just wondering if there is something to use thatll make the job the easyest possible and make it come out the best

[Dunesurfer]

Jigsaw with a fine tooth blade. Tape where you want to cut and cut along the edge of the tape.

yeah use a jigsaw, then afterwards clean it up with a file and sand paper, then you get doewn to like 300 grit, get a heat gun or propane torch and carefully melt the the plastic, after that itll look factory

[sampleez]

i used a fine blade for a hacksaw wrapped in some shop wrags. cause i wasn't too sure of my jigsawing sills.

[enduro400rider]

i used a dremel with a cut off wheel, it worked great and then i used a sanding bit to clean up the cuts real good

[RidrKFX]

air-powered tin snips

[MadMax27]

All I needed, Smooth edges, no fuss

[MadMax27]

Sweeet

[RidrKFX]

a winch on a 400ex :ermm: kinda sad if i may say

[zdog400]

they come in handy if ur a mudder

[Iliketogofast]

Or if you happen to ride with mudders regularly...

[MadMax27]

Pulled plenty of Craptors and Z400's out of trouble, including myself :D

[bwamos]

This is what I use.
Pneumatic Body Saw.

[426ex]

I used the same body saw....Harbor Freight for 19.99

[bwamos]

Yup, yup. ;)