Sturmgiest
08-04-2005, 06:19 AM
I just installed a DRD full race exhuast, prodesigns pro flo intake with foam filter and pre foam filter and took the lid off the box on my 05 yfz.
I installed a NCVQ needle with a 175 main and a 45 pilot
it does ok till about 1/2 throttle then it seems to choke (cutts out) when i give it any more throttle, i've tried adjusting the fuel screw from 1/2 turn out to a little over 3 turns and if keeps doing the same thing.. and i turned the idle so it would idle past 2 1/2 turns I may have turned it too much could that hurt preformance?
i'm new to jetting so if someone can help me out please am i running lean or rich? and should I lower the main or the needle clip?
please help me out guys
I installed a NCVQ needle with a 175 main and a 45 pilot
it does ok till about 1/2 throttle then it seems to choke (cutts out) when i give it any more throttle, i've tried adjusting the fuel screw from 1/2 turn out to a little over 3 turns and if keeps doing the same thing.. and i turned the idle so it would idle past 2 1/2 turns I may have turned it too much could that hurt preformance?
i'm new to jetting so if someone can help me out please am i running lean or rich? and should I lower the main or the needle clip?
please help me out guys