PDA

View Full Version : will this work



kyleschonert
08-03-2005, 08:59 AM
will this kill switch for a dirt bike work as a starter for my 300EX. if so, please tell me what to do with it. http://cgi.ebay.com/ebaymotors/86-Yamaha-YZ125-YZ-125-Engine-Kill-Switch_W0QQitemZ4565923468QQcategoryZ35594QQssPage NameZWDVWQQrdZ1QQcmdZViewItem

and this one
http://cgi.ebay.com/ebaymotors/KX80-KX-80-kill-switch-kx125-kx250-125-250_W0QQitemZ4565008714QQcategoryZ10066QQssPageNam eZWDVWQQrdZ1QQcmdZViewItem

Silverfox@C&DRacing
08-04-2005, 02:23 PM
the kill switch must have 2 internal wires to work as a start switch. We use a kx killswitch.

Pvt. Maggot
08-04-2005, 02:39 PM
I used a cr killswitch. great mod.

redroost85
08-04-2005, 02:58 PM
I run the CR kill switch too and it works fine...although I found out that I had to put a piece of electrical tape on the handlebar that the switch goes over because it was shorting itself out.:p

Silverfox@C&DRacing
08-04-2005, 03:03 PM
you can use the cr style but you will have to tape the bars and when riding in wet conditions it will still shock you that is why we use the kx style because it has a sealed normally open internal switch.

kyleschonert
08-06-2005, 11:43 PM
what all wires do you splice it to. And once i do that, what do i do with the reverse. IVe been reading those other ones so dont tel me to search. They dont really explain it that good and ive heard a few bad things about that. So i may take the reverse off.