PDA

View Full Version : JL audio 300/4 amp



kicker696
07-29-2005, 07:26 PM
I have a JL audio 300/4 amp that i am looking to get rid of, it has a few small scratches on the top of the amp, but other than that is in great condition. I am asking 210 shipped

I also have a Audiobahn Flame Q that i am looking to sell in a Q-logic box taht i am looking to get rid of also. I am asking 150 + shipping for the box and sub.

I will sell as a package for 360 shipped

kicker696
07-30-2005, 12:41 PM
bump

kicker696
08-01-2005, 04:18 PM
BUMP

Airik79mx
08-01-2005, 04:24 PM
Good amp but I have no use for it right now.

kicker696
08-02-2005, 10:54 AM
yeh, it is, i just want somthing bigger, i'm looking at getting 2 w7's so i need money for them

panteramatt
08-02-2005, 02:38 PM
That amp is for highs and mids right? How old is it and whats the watts in rms?

kicker696
08-02-2005, 03:38 PM
here is everything right from there website, the amp is a little over 2 years old, it was in my show S-10, so it hardly got used:




Specifications:


Rated Power (stereo):
75 W RMS x 4 @ 1.5 ohm-4 ohm
(11V-14.5V)

Rated Power (bridged):
150 W RMS x 2 @ 3 ohm-8 ohm
(11V-14.5V)
THD at Rated Power:
<0.03% @ 4 ohm
S/N Ratio*:
>108.5 dB below rated power
Frequency Response:
5 Hz-30 KHz (+0, -1dB)
Damping Factor:
>200 @ 4 ohm per ch./50 Hz
Input Range:
switchable from 200mV-2V RMS
to 800mV-8V RMS
Dimensions:
13.4"L x 9.25"W x 2.36"H

Features:
Differential-Balanced Input Topology:
(2 pairs of inputs)
Front Crossover:
fully-variable (50 Hz-5 KHz),
selectable-slope LP or HP (12 or 24 dB per octave)
Rear Crossover:
fully-variable (50 Hz-5 KHz),
selectable-slope LP or HP (12 or 24 dB per octave)
Speaker output connections:
accept up to 8ga. wire
+12V and Ground connections:
accept up to 4ga. Wire