LT 80 clutch

[ct310]

clutch is slipping & "notchy", I removed the sidecase .Now what ??

[LT80]

Remove the front and rear clutch nuts (right hand thread).
remove the front clutch, disassemble and check for flat spots on the rollers. Also check out the tracks where the rollers run for damage. This includes the roller plate. Make sure the keyway is perfect on the roller plate. Replace any worn/damaged parts if any.
Remove the rear clutch and sand the contact pads "lightly".

During assembly, make sure the keyway is aligned properly (front). Zuki packs the grease in the front, I have abandoned that and just use a dab of high heat grease on each roller, basically to help hold the roller in place during installation.

I suspect a roller problem or maybe even a keyway problem, or both. ;)

[spinout]

anyone have any used clutches for sale?

[spinout]

ttt

[LT80]

What pieces are you looking for?
"clutchs" could mean many parts.