I Got My 400ex!!

[RuBb]

=D through carefull consideration i have decided to get a 400ex... and i got it today im so happy haha heres some pics :)


http://img15.imageshack.us/img15/543/picture0036sh.jpg

http://img15.imageshack.us/img15/999/picture0013wu.jpg

[TRX_450]

wat year? 2002?

the plastics look like new.

I can already tell that you want an exaust.

[DH400EX]

congrats! looks like its bout time for some new tires :macho

[400exredrider]

yeah them rear tires look like hell

[RuBb]

haha yeah she needs some new tires, and the exhaust is a bit dirty, im gona stick wit stock 4 a little while... im 13 and it has plenty of power as it is haha\

can you beleive that only costed me 3500 :D it runs like new

what year was it? I got my 2001 for 2900. And it was mint.

[TwentyBelow131]

400EX's are going cheap now since the 450's. Im glad though because I got my 01 two month ago at auction for $2400

[JDiablo]

congrats

[RuBb]

im talking 3500 canadian funds now folks haha

its a 2002 and i got fox racing pants (200$) and fox motocross boots (400$) and also, went to clean the air filter, and relized it had a k&n filter haha, i guess thats were all the torque is comin from? i think i got a good deal on it

[TwentyBelow131]

3500 canadian is a great deal.

[insaneracin2003]

sweet,have fun with it!!!:macho

Hows it run?

[tater_kamik]

i best to see some good tricks and track pics now!!!:devil:

[RuBb]

theres no tracks were i live, only a few motocross tracks about 500 km away, i mainly ride in sand pits / dirt pits, theres tons around here with lots of hils to climb and everything... she runs great but she has been riden hard and is in need of a clutch kit (clutch is slipping a bit) and some new rear tire bearings, nothing is broke but it would be ncie to have these replaced

[tater_kamik]

no tracks?!? well, you can always make one!:devil: it needs the bearings in the swingarm replaced? good thing honda's are easy!:D

good luck getting the swing arm bolt out.

[tater_kamik]

are you going to replace all of the bearing and seals on the swingarm or do you just need to do the carrier?

The swingarm bolt sucks so bad! Its like impossible to get out!

I just did my clutch plates yesterday in mine it was pretty easy

[RuBb]

im talkin about the wheel bearings

[tater_kamik]

here is the solution for everything, get a bigger hammer!!!:devil: are you saying rear wheel bearings? as in ignore where the axle rotates but bearings on the rear wheels? i must be missing something b/c there arent any bearings for each rear wheel. what are you fixing?

[400exredrider]

heh, i was thinkin the same thing:p