View Full Version : 426>??
tp300ex
07-05-2005, 11:45 AM
Ok i have been looking for a 426 bore kit but can not find one no where. plz give me a website where i can get it!!!!!
jak1389
07-05-2005, 11:51 AM
why dont you just buy the parts you need instead of buying parts you may not need or want.
underpowered
07-05-2005, 12:09 PM
There is not really a big boar kit for a 426. All you need is the piston (J.E., Ross, Or Wiseco) and someone to bore the cylender. There is no sleeveing required so is does not come in a kit. C&D could probably hook you up with a piston
jak1389
07-05-2005, 12:29 PM
it might not be a bad idea to have it resleeved becasue at that bore the sleeve is kinda thin and its pushing it.
tp300ex
07-05-2005, 12:33 PM
i was think of myb a 415 kit is this one eny good?http://www.powroll.com/P_HONDA_TRX400EX.htm
jak1389
07-05-2005, 12:41 PM
NOT AT ALL!!!! you can get the same piston with the clips and rings and wrist pin for like $130 and top end gasket kit for $40. The total is $170 saving you $60.
tp300ex
07-05-2005, 04:31 PM
but is that every thing u need ?
tp300ex
07-05-2005, 04:42 PM
http://www.microsoft.com/isapi/redir.dll?prd=ie&ar=windowsmedia
this?
darkstar
07-05-2005, 05:14 PM
here this is what i am having done buy c&d, you will also need a cam to go with the bore to really get good power gain.
Engine:
JE 416 $120
cometic steel flex gasket kit $40
stage 2 hotcam $114
port and polish $175
valve seals $5
3 angle valve job $65
cylinder bore $60
exhaust gaskets $2.10 each
oil filter $5
labor $250
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.