yfz450inMI
06-30-2005, 06:29 AM
The quad was just completely gone through.
Frame was painted a purple metallic from a late model mustang
Plastic is brand new silver Mier race cut, with black hood
Seat has been recovered
Tires are Holeshots - 18x11-8 rear and 21x7-10 fronts on ITP rims
Axle is a +3
A-arms have been chrome plated
Swingarm is a +4 and is also chrome plated
Twist throttle
Engine:
1991 CR500R
Ported and polished
Crank balanced by Crankworks
Less than 20 hrs on rebuild
Includes all electronics - CDI, brand new coil, wiring harness, etc.
Carb (38MM Mikuni) and air filter included along with drag pipe, silencer and spark arrestor.
A stock CR500 is known to put out 65hp.
There was a small spot on right side case half where fluid leaked. Has been patched with some JB quick weld.
Motor runs extremely strong. Will fire right up is the proper procedure for starting a CR500 engine is followed.
Extras:
Yellow plastic race cut - pretty rough but usable
Stock swingarm w/ bearing carrier and new bearings
Bottom half of stock engine - 250cc 2 stroke
Couple exhaust pipes and silencers
Asking $2200 obo for all.
Pics available upon request. If it doesn't sell in 2 weeks, it goes to Ebay to get parted out.
http://www.imagestation.com/picture/sraid168/pedca54511b232b966cb4d6ee4171ee24/f4227c08.jpg
http://www.imagestation.com/picture/sraid161/p9f9279c45516a8036ee67e0f903016b2/f4c08c2b.jpg
Frame was painted a purple metallic from a late model mustang
Plastic is brand new silver Mier race cut, with black hood
Seat has been recovered
Tires are Holeshots - 18x11-8 rear and 21x7-10 fronts on ITP rims
Axle is a +3
A-arms have been chrome plated
Swingarm is a +4 and is also chrome plated
Twist throttle
Engine:
1991 CR500R
Ported and polished
Crank balanced by Crankworks
Less than 20 hrs on rebuild
Includes all electronics - CDI, brand new coil, wiring harness, etc.
Carb (38MM Mikuni) and air filter included along with drag pipe, silencer and spark arrestor.
A stock CR500 is known to put out 65hp.
There was a small spot on right side case half where fluid leaked. Has been patched with some JB quick weld.
Motor runs extremely strong. Will fire right up is the proper procedure for starting a CR500 engine is followed.
Extras:
Yellow plastic race cut - pretty rough but usable
Stock swingarm w/ bearing carrier and new bearings
Bottom half of stock engine - 250cc 2 stroke
Couple exhaust pipes and silencers
Asking $2200 obo for all.
Pics available upon request. If it doesn't sell in 2 weeks, it goes to Ebay to get parted out.
http://www.imagestation.com/picture/sraid168/pedca54511b232b966cb4d6ee4171ee24/f4227c08.jpg
http://www.imagestation.com/picture/sraid161/p9f9279c45516a8036ee67e0f903016b2/f4c08c2b.jpg