400exstud
06-29-2005, 08:53 PM
This is all for a 400ex
Question 1: Where are the main and needle jets located? Are they both inside the float chamber? Will I be able to adjust the needle clip here?
Question 2: When I am taking apart the carb to get into the float chamber is there anything that I need to worry about (such as springs that go flying or very small parts that could fall and never be found again).
Question 3: The air/fuel mixture screw is located on the outside of the carb? (I am pretty sure but just checking)
Question 4: I drained the float chamber but how does more gases get in? Will the float device just automatically fill up the float chamber once I hook the gas tank and fuel line back up? If not how.
Any other tips or advice would be GREATLY appreciated.
Question 1: Where are the main and needle jets located? Are they both inside the float chamber? Will I be able to adjust the needle clip here?
Question 2: When I am taking apart the carb to get into the float chamber is there anything that I need to worry about (such as springs that go flying or very small parts that could fall and never be found again).
Question 3: The air/fuel mixture screw is located on the outside of the carb? (I am pretty sure but just checking)
Question 4: I drained the float chamber but how does more gases get in? Will the float device just automatically fill up the float chamber once I hook the gas tank and fuel line back up? If not how.
Any other tips or advice would be GREATLY appreciated.