biggun400
06-17-2005, 08:37 PM
Hey guys! I tried changing the rear brake pads the other day. My caliper wouldn't go in far enough to let me slide the pads back over the rotor so I took the back part of the caliper off, (the part where the emergency brake hooks up). The caliper then slid back out of the way fine. I put everything back together the same way it came apart and tried bleeding the lines. Brake fluid squirted out whenever I hit the pedal, but now the caliper won't respond. I know it's getting fluid to it. Did I mess something up? The only thing I know that I did differently was put DOT3 brake fluid in there instead of DOT 4. Should this cause a problem? Let me know what you think. Thanks