Knarf0486
06-15-2005, 02:23 PM
i am replacing the clutch on my 02 400 ex and i am having some problems. i replaced everything the way it came out. put the friction disk in first, alternated them between the disks and plates and the outside disk is in the shallow tab like it supposed to. but when i tighten the springs down and replace the crankcase cover the clutch wont disengage the gears.
i will put it in gear and pull the clutch in and the will not move, it catches the gear as though i wasnt pulling in the clutch at all. ive tryed adjsuting the cable at the perch but still doesnt roll. if i push it enough it will eventually move.
am i not supposed to tighten the springs down all the way or is there a certain way that the pressure plate is supposed to go one. if anyone has any ideas shoot them my way. i wanna get this done for the weekend. thanks
i will put it in gear and pull the clutch in and the will not move, it catches the gear as though i wasnt pulling in the clutch at all. ive tryed adjsuting the cable at the perch but still doesnt roll. if i push it enough it will eventually move.
am i not supposed to tighten the springs down all the way or is there a certain way that the pressure plate is supposed to go one. if anyone has any ideas shoot them my way. i wanna get this done for the weekend. thanks