Glamis400ex
05-24-2002, 09:12 PM
Hi gang,
I will be taking my rear shock to be re-valved here on Monday to match my triple w/ rezzie up front.
Well, I sucsessfully took it off and, just for kicks, tried to re-install, just to see how tough it will be. It looks like a pain. The holes wont line back up. I can get the top no prob, but the bottom is a little trickier.
I have the quad up on a 5 gal. bucket, raising all 4 wheels off the ground and put a jack under the swingarm for support.
NOTE: It is wise to first remove your skid plate before trying to remove the bottom bolt, thought I would pass on this little tip.
So, what's the trick to line up the holes? Sorry if this is a ridiculous post, but this is a first time job for me..........
Thx for any help...
Glamis
I will be taking my rear shock to be re-valved here on Monday to match my triple w/ rezzie up front.
Well, I sucsessfully took it off and, just for kicks, tried to re-install, just to see how tough it will be. It looks like a pain. The holes wont line back up. I can get the top no prob, but the bottom is a little trickier.
I have the quad up on a 5 gal. bucket, raising all 4 wheels off the ground and put a jack under the swingarm for support.
NOTE: It is wise to first remove your skid plate before trying to remove the bottom bolt, thought I would pass on this little tip.
So, what's the trick to line up the holes? Sorry if this is a ridiculous post, but this is a first time job for me..........
Thx for any help...
Glamis