Removeble Ball-Joints on Stock A-arms??

[Pro400EXC]

Hey guys,I was wonder if this would work.

1.Cut the stock ball-joints off the a-arms (400ex) then slide some Lonestar or Burgards or some kind of Ball-Joints in there? Then just tighten them down with the nuts?

CVause my a-arms are rustin bad and spray paint don't hold up too well. so will this work?

Thks,Pro

[PDunes300ex]

Just save your nickles and dimes...live with the rust for a little bit then buy aftermarket arms. Youd have to machine press out the stock ball joints and im not sure that aftermarket ones would seat correctly in the stock arm. Honda used a cheap stock setup that is not serviceable or replaceable. As far as cutting them out...that sounds a little too risky.