View Full Version : base gasket
DISHO1
05-21-2002, 09:57 PM
has anyone tried the honda bond ht silicone as the base gasket with the xr400 head gasket? where there any problems with this set up? i am going to use the stock piston and xr400 cam, but i do not have anything to measure the deck height so i am worried about clearance problems. is this a sure " bolt-on" with no problems?
First you should at min get a cheap set of calipers or something to get a measurement, as it may be helpful in the future.
There is a thread titled "have you decked the cylinder" that discusses this as well. Check it out its a great thread.
Powered by vBulletin® Version 4.2.1 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.