jpconard
05-23-2005, 09:52 PM
Just took off swingarm from 250EX. It was solid (no side to side play) but I wanted to lube the swingarm bearings.
When I got it apart, the shaft side bearing would pivot the wrong way and when I removed the seal, the balls came out. The other side was fine.
I was able to grease it and put the balls in the retaining cup and set then in the outer race (in the arm), then I took a socket and gently tapped the inner race back in. It is together now and doesn't pivot the wrong way (just turns normally).
Is this normal or is this a bad bearing? This is only an 04 with not too much riding on it.
I was going to order some replacements from Rocky Mountain (before the weekend) but they are out of stock.
I think I am going to get some more grease tomorrow and just get it back together.
Down the road when I probably will replace the bearings and seals, how do I remove the outer race?
It seemed pressed into the swingarm pretty solidly. You also can't get to it from the opposite side since the swingarm is sealed in the middle (shaft drive).
When I got it apart, the shaft side bearing would pivot the wrong way and when I removed the seal, the balls came out. The other side was fine.
I was able to grease it and put the balls in the retaining cup and set then in the outer race (in the arm), then I took a socket and gently tapped the inner race back in. It is together now and doesn't pivot the wrong way (just turns normally).
Is this normal or is this a bad bearing? This is only an 04 with not too much riding on it.
I was going to order some replacements from Rocky Mountain (before the weekend) but they are out of stock.
I think I am going to get some more grease tomorrow and just get it back together.
Down the road when I probably will replace the bearings and seals, how do I remove the outer race?
It seemed pressed into the swingarm pretty solidly. You also can't get to it from the opposite side since the swingarm is sealed in the middle (shaft drive).