CR250 Plug Fouling HELP

[1337]

2005 CR250

My plug is black and wet when I foul them.

What can I do to correct this?

My Gas is perfectly Mixed.

Would just adjusting my Air/Fuel Mixture screw work?

If so what way?

Any other suggestions on how to prevent fouled plugs let me know please.

Also what is best plug in your own opinon for CR250 Motors?

[Silverfox@C&DRacing]

is the plug gas wet or oily wet?

[400exredrider]

quit babyin it :D

[1337]

Oily wet.

[Silverfox@C&DRacing]

what brand of 2 stroke oil are you using? and what are you mixing it at?

[2muchquad]

since that is a new bike,i doubt your crank seal is shot,i would go with a smaller pilot or start riding the bike the way it was intended.your probably puttin around on it and its loading up on you,thats not the bike for leisurely trail riding.gotta open it up from time to time.also mixat 32 to 1 or so.a lot of the manuals on the newer bikes will tell you 20 to 1 or something like that.32 to 1 and you'll be fine.oil brand isnt important as long as its of quality.no lawnboy or weedwacker oil in your cr..:D

[EX400rider]

Yea dude hold her wide open to blow her out!

[RiderTRX400ex]

HAMMA THAT THING, thats what their for!

[RidrKFX]

Man just like hold it open for like 2.395 min. then see if you can hit rev limiter and like show it whos boss.

[300exr]

Hows your reed valve, My Yz 125 was doin the same thing n i couldnt figure the thing out, so i decide to by some new boyesson reeds for the hell of it and what do ya know, ran perfect