Tranny oil filling trick

[kbass24emtp]

Here is a little trick that I use to fill my tranny oil. It is different than the way Honda tell you how to do it. First here is the tools needed for the job. A 10mm allen key, tranny oil, and a flash light.

[kbass24emtp]

Next remove the Crankshaft hole cap with the 10mm key.

[kbass24emtp]

Now with the cap removed see the crankshaft bolt. Your going to use that as your guide when to stop filling.

[kbass24emtp]

See the pink mark on the flange on the bolt, that is you guide

[kbass24emtp]

Now fill your tranny with whatever oil you choose. I will be easier for the people using tranny oil because of the container.

[kbass24emtp]

Using a flash light makes seeing the oil easier.

[kbass24emtp]

When the oil reaches the bottom of the flange your full.

[kbass24emtp]

Now put the crankshaft cap back on and torque it to 11 ft-lbs and your done. No mess and alot easier. Hope this help some of you out.

[Moto92]

OK...now figure me out an easier way to drain it and you'll be the MAN!

[nat3060]

i dont have a problem using the black screw to put the tranny oil in

[kbass24emtp]

My job was the filling your job fearthisracer is the removal. Haha just kidding. :devil:

[honda350r]

Or just drain and measrue out 650 cc or ML and fill the damn thing up !!

[kbass24emtp]

That works if 650cc comes out.

[culookn]

good idea, gonna have to try it out tom.